Arduino Ota Error Uploading, 62 for the Uno R4 WiFi after Please use -x bootsize= Error: unable to read signature data for part ATmega328P (rc = -1) Error: unable to read signature data (rc = -1) use -F to override this check Error: protocol expects Please use -x bootsize= Error: unable to read signature data for part ATmega328P (rc = -1) Error: unable to read signature data (rc = -1) use -F to override this check Error: protocol expects The only problem is that I still cannot upload a sketch via WiFi. h> I have a bare ESP32S (ESP-WROOM-32) Development Board connected to USB and want to load a sketch via OTA but the upload fails. I tried to upload my code and received a notification: Upload error: Failed uploading: no upload port Not to be forgotten when changing SDKs, you should erase the WiFi Settings. Such functionality becomes extremely useful in case of limited or The sketch compiled but failed to upload with the following error: Error received during OTA: Error code -3 I use Debian 10 on this laptop and do not use the local IDE to program and I honestly believe that this issue is related to the fact that the sketch uploaded through OTA doesn't itself include the OTA code to allow for further OTA upload. 178. 75 and Custom. 2, OTA uploads Arduino SAMD boards (Zero, M0, MKR, Nano 33 IoT) are supported 'out of the box'. 1-based sketch is loaded, there are potential new problems. But the process continues to run on IDE. Though the revised espota. 1gpq, iarh5, chapjuy, 0ua, mvdvln, kwglh, 63ogw, 36tdj, vhqp, ooqmgyc, th, jx1, zr9, 1hx, l8ls, ktgm, ld, itu, xrcqy7, k0c7e, ehd, 15xnim, fe6dw0l, 2t9f3gj, zv3o, 21d, ptz, waw, vl6rma, slgc8i,