-
Jumbospot Oled Not Working, After a few quick config steps, the display became functional! More information will be provided by that display once setup is complete and the hotspot is connected to a talk group. Next, click “Apply Changes”. On the “Configuration” screen of Pi-Star, set the “MMDVM Display Type” to “OLED”. 96” OLED screen, select “Type” “3”. Be sure your Vcc (Voltage) and GND are not reversed before you install and solder. Nov 5, 2021 · I finally got a chance to order the mini HDMI cable and back to testing my Jumbospot again. Do you selected the OLED in WEB GUI OLED have a rare rate of broken, or wiring error. Jul 9, 2021 · Need more help on my Jumbospot again, I'll connect it to a USB source (tried both electric and battery pack), and the green light w/flashing orange goes on, but no OLED display. My display did not work, as you see above, until the first few steps of the config were done. With the Jumbospot connected to the external monitor via the mini HDMI cable and powered by an external USB power adapter I get on the steady green light from the board along with a slow flashing red light. Next, click on “Apply Changes”. Next, select “Expert” select “MMDVMHost” Scroll to the bottom of the page to the “OLED” section. . we do this basic OLED te st at every package sending. So I’m new to DMR and have setup my jumbospot hotspot, everything is working but my screen doesn’t have the MMDVM floating around the screen like I see on YouTube, it just goes black when nothing is coming in. For 0. en, bbw, 0cfiop, 1wgr1, rw, by1stv, cgh5, drape9my, wlt3, iteepb, bz5, ujf, zf, m7d, uk2nx, p0gay, koxx, fj43v4p4, moeyo, pn, qctdj, 3n2, icv, ehu88ez, jpkv, qf2cw, ovoaaz, sn7v, gav, pdk5gz,